Welcome to carpricebd.com. We all know that carpricebd.com always try share important knowledge and information to motor car driver, lover who want to update himself. Today we want to discuss about some another imports issue/problem/question and its solution as well that is very much helpful before he/she start to drive the motor Car. Please read below question and answer carefully and learn how to solved the issue if happen;
Question: - What to do if you suddenly break the current route?
Answer: - When the break the current route then EP5 switch should be switched off and the car will be brought into lower gear.
Question: - Once the electric horn is played, what should be done if it is constantly ringing?
Answer: - If motor car electric horn ringing continusly then immediately cut-out will stop after its opening.
Question: - What is the reason for charging the m meter after starting the EP3 switch?
Answer: - It looks like the battery is overturned. Discharge will show when the engine is turned on.
Question: - Why not stop pushing while the car is moving, again without any noise or push?
Answer: - When the car is stopped to push, it is necessary to understand that there is a disturbance in the petrol line; And if there is noise or shutdown without pushing, it is important to know that there is a noise in the electric line.
Question: - Why does the car sometimes move in one direction when the brake pedal is pressed in the car?
Answer: - (a) If the brake line is not properly adjusted, (b) if the four wheels are not properly filled with air, (c) if the path is delayed, (d) if the brake is tightened to run at speed.
Question: - What is the clutch requirement?
Answer: - The clutch is located in the middle of the engine and gear box. The power of the engine is carried out in the gear box during different speeds of the vehicle.
Question: - What is the purpose of having a gear box?
Answer: - The purpose of having a gear box is 2: (1) change of speed of the vehicle Make and (2) drive the car backwards. These two objectives are accomplished by changing the position of the gear.
Question: - How many types of axles are there?
Answer: - Axil is mainly of two types. (1) Dead and (2) Live. The dead axle is in a cow carriage. It is firmly rotated with wheels not rotating. And the live axle rotates with the wheels themselves.
Question: - How many types of live (or rear) axils are there?
Answer: - Live (or rear) axles are mainly of three types. (1) Half Floating (2) Three Quarter Floating and (4) Full Floating
Question: - What is the type of tire?
Answer: - Tires are of two types. (1) Including tubes and (2) without tubes.
Question 3 How does the tire harness hurt?
Answer: Apart from excessive travel, various oils, grease and diesel fuel damage the tire. Electric motors, gas heaters and intense sunlight are also the major causes of tire damage. Ultra violet rays of sunlight cause the tire to begin to decay.
Question: - What is suspension and what is its function?
Answer: - Spring shapes of different sizes are fitted to the front and rear axles. Road bumps and steep sidewalks prevent these springs from being seriously damaged. This process of suspension tolerance is called suspension. So the job of suspension is to drive the car smoothly in any way.
Question: - What does the internal combustion engine mean?
Answer: - The engine that burns the fuel in its own interior is called an internal combustion engine. For example, petrol and diesel powered motor vehicle engines.
Thank all for reading.